LC fit and clearances for bodywork
LC fit and clearances for bodywork
Should the gap between the tank and the left side panel be bigger than the right?
Ex UK, now in Adelaide. LC250/350. DT175. Shed full of sh1t in the vague form of dismantled rusty RD’s and RZ’s.
Re: LC fit and clearances for bodywork
This happens when the brackets get punched around in accidents, tho they werent perfect when new. you can move the brackets around with a plastic or rubber mallet but dont go mad.
Re: LC fit and clearances for bodywork
The brackets look straight, the midsection of the frame looks straight and level, almost like its a “peculiarity” rather than an issue.
LC’s are thin on the ground here.
What do yours look like in this respect Jon?
LC’s are thin on the ground here.
What do yours look like in this respect Jon?
Ex UK, now in Adelaide. LC250/350. DT175. Shed full of sh1t in the vague form of dismantled rusty RD’s and RZ’s.
Re: LC fit and clearances for bodywork
They are all a bit different, some better than others. Ive adjusted a bit, its only a few mm you can play with tho.