fitting Boysen reeds to a Mito
Posted: Fri Apr 08, 2011 5:07 pm
when fitting Boysen reeds to the Mito, is it a straight swap for the original reeds? will i need anything else to fit? 
2 Strokes Down Under
The 2Stroke website for the Southern Hemisphere
https://www.2strokesdownunder.com/
fitting Boysen reeds to a Mito
Page 1 of 1
Re: fitting Boysen reeds to a Mito
Posted: Sat Apr 09, 2011 12:15 pm
A V Force reed block
Re: fitting Boysen reeds to a Mito
Posted: Sun Apr 10, 2011 10:12 am
yes i need more mito stuff.good luck
Re: fitting Boysen reeds to a Mito
Posted: Sun Apr 10, 2011 2:43 pm
+1 Vforce
otherwise, If your just buying reeds make sure they are disigned for the OEM mito reed cage...
If you are buying a whole boysenn reed cage for the mito, it should bolt right on plus some jetting changes to the carb
but I would recommend ditching the boyesen rad valve and getting a vforce too
otherwise, If your just buying reeds make sure they are disigned for the OEM mito reed cage...
If you are buying a whole boysenn reed cage for the mito, it should bolt right on plus some jetting changes to the carb
but I would recommend ditching the boyesen rad valve and getting a vforce too