2 Strokes Down Under

Fly wheel can't move, i've checked it.
I don't know about the oil pump, but can it give so much trouble?
Because i've always used the pump, can it explain this behavior?

I'm just using the oil pump on the bike and how could the timing change, it has a fixed ground plate..

I don't know, I don't have a rpm-counter.
But i tested the bike with several jets, and the sparkplug is wet when i pull it out.

So i think it is not completely burning the fuel, but correct me if i'm wrong

Update: I just noticed that i didn't put the exaust gasket in the exaust port.
the gasket helps a little bit but it is just 4km/h, it still will not run higher than 30km/h.

Yeah i was also going for the cheaper one :wink: Yes even if i apply less throttle the bike would not go any faster, it is like it is limited(restricted) altough the restriction was fully out of the exausth and the cdi is not restricted. And yes it just stops accellerating at a certain speed, it jus...

It sounds as though you have replaced every other part but the stator. When considering the entire system, there is only a couple of things left: 1) Carb/Fueling issue 2) Stator As far as the stator goes, more resistance generally means less current flow. Is the stator expensive to replace? Carb ha...

There are forums from rieju and i already posted something there, but there is not as much activity on that forum.
It's almost only one guy that answers.

But maybe there is someone who can tell me what the symptoms are for bad stator.

And yeah i like them too

Hey guy's, I'm from Belgium, but I'm trying to figure out my problem with my bike. So I was riding my bike(with restriction = 50km/h) and at some moment I felt that I was losing power. But because I was going to replace the cylinder and piston when the parts arrived I just drove it a few more kilome...