Page 1 of 1
What's involved in "rebuilding" a crank?
Posted: Sat Aug 02, 2014 4:52 pm
by Greasemeup
Just curious what a typical rebuild is, what are the goals of a rebuild?
Re: What's involved in
Posted: Sat Aug 02, 2014 8:05 pm
by hybrid
Basically replace any parts that are out of spec (cank bearings/big end bearings/rods/thrust washers etc) and then press it all back together and true the flywheels to spec with a soft (copper etc) hammer/drift.
Re: What's involved in
Posted: Sun Aug 03, 2014 10:58 pm
by BRG1200
Have a look on youtube, not sure here are any greatbsbecrets revealed like trueing with a copper mallet etc, but there are a few vids showing cranks being pressed together etc