Page 1 of 1
R5
Posted: Sat Nov 20, 2010 8:16 am
by HM31A
anyone know anyone slotted a rz5 engine into a R6 frame and if so is there a kit available or just one of these one off projects
Re: R5
Posted: Sat Nov 20, 2010 6:47 pm
by wheels999
Its been done... some guy in Melbourne I think. No kit as far as I know.
http://www.motoblog.it/galleria/special ... ri-500cc/6
Cheers, Markus.
Re: R5
Posted: Sat Nov 20, 2010 9:25 pm
by HM31A
markus
thanks for that
looks good
pic up the roller today
poor guy went bush so needs new forks and a front wheel
2 years in rehab and lost an arm so hopefully all the bad lucks gone from the bike
cheers mike
Re: R5
Posted: Tue Dec 07, 2010 8:42 pm
by hyside
Yep Markus is right, its been done and the guy was from Melb.
Pete Gibson made the Pipes for it, I have some pics of it some were I think, Pm me your e mail and I will sort them out for you.
Nobby
Re: R5
Posted: Tue Dec 07, 2010 10:24 pm
by HM31A
nobby
thanks for that
people say the bikes to wide for the mod so it would be interesting to see how it looks
seen a rg5 into a r6
cheers
Re: R5
Posted: Thu Dec 09, 2010 9:02 am
by hyside
Did you get the pics OK ?
Re: R5
Posted: Thu Dec 09, 2010 1:21 pm
by HM31A
hyside wrote:Did you get the pics OK ?
yes i did
thanks alot
his is a little later model than mine as he has the udf but gives me a good indication of the end result
you say hes in melbourne anyone else seen the bike up close or even better know how to contact him
you think he did the work himself or subed it out to a builder
cheers mike
Re: R5
Posted: Fri Dec 10, 2010 9:16 am
by hyside
I will go back through the order book and see if I still have his contact details, I belive he did all the work himself.