H100 Bucket Racer project
Posted: Fri Jan 07, 2011 10:20 am
I need to fund some improvements to my LC, so the bucket has to go. I started this project about five years ago and never got around to finishing it.
The frame is a Honda H100S and the motor is a H100A (could be the other way around, can never remember).I spent a fair few dollars buying new stuff for the engine, but can't remember what. I think it may have been a new piston, rings, bearings etc. All the new parts were fitted but the engine has never been started. I suspect it will need new gaskets by now, as the home made ones I put in probably haven't held up well with time.
The tank is a hollow, hand crafted fiberglass job. I was going to fit a small lawn mower tank underneath. I have the lawn mower tank here, ready to go.
The tail is also made of fiberglass and I have an unpainted spare.
New Michelin tyres are fitted. It has custom mounted GSXR rear sets and some sort of race pipe.
I honestly have no idea what is left to do to make this run. It needs a carbie (I have one in a box of spares), the tank needs to be fitted and I think the clutch and throttle need to be connected.
Plenty of pics attached, can provide more.
Bike will go to best offer after a week or so, and I might even throw it up on eBay for a bit.
Contact me at: mrearthpig@gmail.com
The frame is a Honda H100S and the motor is a H100A (could be the other way around, can never remember).I spent a fair few dollars buying new stuff for the engine, but can't remember what. I think it may have been a new piston, rings, bearings etc. All the new parts were fitted but the engine has never been started. I suspect it will need new gaskets by now, as the home made ones I put in probably haven't held up well with time.
The tank is a hollow, hand crafted fiberglass job. I was going to fit a small lawn mower tank underneath. I have the lawn mower tank here, ready to go.
The tail is also made of fiberglass and I have an unpainted spare.
New Michelin tyres are fitted. It has custom mounted GSXR rear sets and some sort of race pipe.
I honestly have no idea what is left to do to make this run. It needs a carbie (I have one in a box of spares), the tank needs to be fitted and I think the clutch and throttle need to be connected.
Plenty of pics attached, can provide more.
Bike will go to best offer after a week or so, and I might even throw it up on eBay for a bit.
Contact me at: mrearthpig@gmail.com