Page 1 of 1
recommendation for a cylinder boring in Melbourne
Posted: Fri Feb 08, 2013 12:22 pm
by fred99999au
Hi All. Need a recommendation for a cylinder boring in Melbourne.
Anyone have a good lead? air cooled single cylinder 86mm piston size.
Re: recommendation for a cylinder boring in Melbourne
Posted: Fri Feb 08, 2013 2:32 pm
by Jeram
plenty of places will be able to do it for you, but if your struggling I can take it with me to shepparton in a couple of weeks and get it done for you as the guys up there do a good job for a very good price
Re: recommendation for a cylinder boring in Melbourne
Posted: Sat May 25, 2013 10:14 am
by s4oz
Hello all
Just seized rear right cylinder in my RZ500 restoration.
I would like to have someone look at it and bore/hone as needed.
As per OP question, I am looking for a reliable shop in Melbourne, prefer South 'burbs.
Thanks in advance.
Re: recommendation for a cylinder boring in Melbourne
Posted: Thu May 30, 2013 11:35 am
by fred99999au
Cant help in the south, but had my 400D cylinder bored at Hoppers Crossing and it looks like they did a nice job. Just waiting for bearings to assemble the cases and then I will know for sure.
I can find the mob if you need. Most engine re-conditioners should be able to help.