2 Strokes Down Under

Hi guys

live in Mackay, beautiful part of the world

I bought a tired old rz350 a while back that I am now trying to get the engine running.
And sad to say, I think one of the barrels has been cooked.

Chasing any rz parts that your would part with? 

Specially a working set of barrels .

Attached is image of piston wall.(left)

I also measured the sizes and they are both 66mm dead on +/- 0.05mm

So here's hoping I can resurrect this baby.

Stephen clarkson.

Left


Right

Hi SteveI,

I seen an ad recently on Gumtree out of Tazzie that lists what you need.

Best luck.

GMU..


Sent from my iPhone using Tapatalk

If you go 250 I can help, Ive a few sets of 250 cyls, but no 350s.

Sent some pictures of to the US to see if they want to have a go at boring and plating them, fitting a matching set of pistons. Order some billet power valves, new reeds, carb kit, water pump, water pipes. Haven't even done the crank yet, but most likely will also need a rebuild.
I thing the only thing that will not need doing is the seat is good...

I might let a set of low bore 350 cyls go if you get really stuck, sadly these things are never cheap now :/