2 Strokes Down Under

Thanks JonW Will check out Norbo's info but I think I know what the answer is.... Swap flywheels The stator on the LC is a charge only unit from TSS with a programmable CDI So it matters not which flywheel, then put the OEM one back on the rz, the hard part is Elsie is my best girlfriend and usually...

G'day All This probably sounds like a silly question BUT can anybody tell me if all flywheels are the same internal diam. I pinched the flywheel off my 87 rz250r to put on my LC, the rz was running ok at the time, I then bought a S/H flywheel for the rz but now have no spark, been diagnosing the pro...

I thought I knew a bit about bikes and old fashioned damper rod forks, well maybe not, when I rebuilt my 350 LC I fitted new tubes, new seals and Hagon springs and carefully measured the oil, well I now can't believe I have NO yes ZERO damping left just bouncy-bouncy with no lose of oil anywhere. I ...

G'day Smokers I rebuilt my 350LC with a few mods but kept it looking nearly std it will rev to 10k and has torque in the mid range, now I want to build a special for the road of cause, got a reasonable condition 87 RZ250r and have just acquired a 95 RGV250 it's rego'd but i'm happy to cannibalise it...

G'day ozwiz
I have a set of 87 RZ250R calipers which I wont be using because an RGV250 front end will be going on
these calipers were seized on and I had to remove them to bring the bike home
Don't think there would be any diff with them

Cheers FNQGreg

Hi Jeram
Have you sold this engine yet ???

FNQGreg

I used VHT but a leaky new fuel tap didn't do it much good maybe they were not baked long enough will have to do it again

G'day Everbody Just announcing my arrival to the forum I have just completed a 2yr+ resto of my 81 RD350 LC named Elsie yes I know not very original but there ain't many of them here in the Cairns area. I also have a slightly sad 87 RZ250 R awaiting my attention which I purchased for $200 and is a r...